CATALOG
[object-name
[library-id]]
|
Related commands: SAVE |
STOW |
UNCATALOG.
This command is used to compile the Natural programming object currently in the source work area of an editor and (if the syntax has been found to be correct) store the resulting object module in the Natural system file.
See also:
Natural
Compiler in Natural System
Architecture
Object Naming
Conventions in Using Natural
Important:
The CATALOG command cannot be used if
the profile parameter RECAT has been set
to ON; in this case, use the STOW command to compile
and store the object.
| CATALOG |
If you do not specify an object-name, the
object is cataloged in the current library under
the name of the object last read into the source work area (for example, with
|
|---|---|
| CATALOG object-name |
A new object is created. As object-name, you specify the name under which the new object is to be cataloged. It is stored in the current library. If the object exists, the command is rejected. |
| CATALOG object-name library-id |
If you want the new object to be cataloged into another library, you must specify the library-id of that library. If the object exists, the command is rejected. |
Note:
If an FDIC system file is specified in the
parameter
module which is not valid, Natural will display an appropriate error
message when the CATALOG command is issued.
