XCO2001E Error during READ of startup parms.
|
Bad file format or I/O error during read of startup
parameter file.
|
Parameter file must be a SAM or an ISAM file with
variable or fixed record length.
|
XCO2002E More than :1: parameter cards not
possible.
|
The maximum number :1: of startup parms is exceeded.
|
Reduce the number of startup parm cards in the parameter
file. Check the default values of the parameters to avoid setting the values
explicitly.
|
XCO2004E X-COM abended.
|
An unrecoverable error has occurred. X-COM terminates
abnormally.
|
Look at the previous error messages of X-COM. |
XCO2005E Wrong X-COM parameter :1:.
|
An invalid value for :1: was specified in startup
parameters.
|
Verify Entire Systems Management Adapter :1: startup
parameter and set a proper value.
|
XCO2007E BS2000 V.2 or above is required.
|
The Entire Systems Management Adapter is compiled for
BS2000 Version 2 or above. It cannot run on OSD Version 1 or below.
|
Upgrade of BS2000 is required. |
XCO2010E Macro :1: RC :2:.
|
The BS2000 macro :1: has returned an error. :2: contains
the return code. X-COM nucleus terminates abnormally.
|
Contact Software AG if return code does not explain the
problem.
|
XCO2011E MAIN MP - Macro :1: RC :2:.
|
The ESAMAIN memory pool creation has been aborted. The
BS2000 macro :1: has returned an error. :2: contains the return code. X-COM
nucleus terminates abnormally.
|
Contact Software AG if return code does not explain the
problem.
|
XCO2012E STACK FAILURE in function :1:.
|
The internal stack is corrupted. :1: identifies the
failed function. X-COM nucleus terminates abnormally.
|
Contact Software AG. |
XCO2014E MAIN MP - Requested space exceeded.
|
The allocated memory size is not sufficient to contain
all required data structures of Entire Systems Management Adapter. X-COM
nucleus terminates abnormally.
|
Contact Software AG. |
XCO2016E Spool subsystem is not active. Set
SPOOL=NONE.
|
The spool subsystem is not active. |
Set startup parameter SPOOL=NONE .
|