Configuring a Routing Notification
Use the following procedure to create and configure a routing notification.
To create a routing notification
1. Start Software AG Designer.
2. Select New >Adapter Notification and do one of the following:
If you are using
Designer, be sure the parent namespace is selected and type a name for the adapter notification. Click
Next.
3. Select Adapter for SAP as the adapter type and click Next.
4. From the list of available templates, select Routing Notification (synchronous) and clickNext.
5. Select the routing listener wm.sap.internal.ls:routingListener. Click Next.
6. Select the service that should be invoked by this routing notification. Click Next and then click Finish.
7. On the Transport Settings tab, type in values for fields Sender, Receiver, and Message to assign the routing notification for corresponding inbound messages.
8. Select one of the following transports from the Transport field and specify the additional information that is specific to the type of transport you select. For information about the additional parameters that you need to supply for each transport, refer to the page indicated below.
Select this transport... | To... | Page |
IS | Route the message to a service. | |
ALE | Route an IDoc to an SAP system | |
RFC | Route an RFC to an SAP system | |
BAPI | Route a BAPI to an SAP system | |
XML | Post a bXML, IDoc- or RFCXML or any arbitrary XML document to a URL. | |
Note:
All but the IS transport will override the service you assigned to the routing notification in step 7.
9. Click Save in Designer to save the routing notification.
10. Enable the routing notification through the Integration Server Administrator.