This Natural profile parameter can be used to overwrite the
definitions in the translation table
NTTAB2 as contained
in the configuration module
corresponds to the
macro in the Natural parameter module.
|Possible settings||See TAB2 Parameter Syntax.|
|Default setting||As specified within the macro
|Dynamic specification||yes|| This parameter can only be specified dynamically. In the
parameter module, the macro
|Specification within session||no|
NTTAB2 table in
the alternate input translation table for the secondary character set used when
the profile/session parameter
PM is set to
The following topics are covered below:
The TAB2 parameter is specified as follows:
You specify pairs of characters, the first character of a pair being the character to be translated, the second character of a pair being the character into which the first character is to be translated.
You can specify each character either as the one-byte character itself (enclosed in apostrophes) or as the hexadecimal representation of that character.
TAB2=OFF all (static and dynamic) definitions are
reset to the values specified in the macro
NTTAB2 macro is specified as follows:
OFFcannot be specified with the macro
NTTAB2, but only dynamically with the profile parameter
TAB2 parameter, you must enclose the
entire string of character pairs in parentheses, for example:
In this example, the character represented by
'ö' into the character
H'78', the character represented by
H'FF' into the character represented by
'ü' into 'Ü'.