This Natural profile parameter can be used to overwrite the
definitions in the translation table
NTTAB1 as contained
in the configuration module
corresponds to the
macro in the Natural parameter module.
|Possible settings||See TAB1 Parameter Syntax.|
|Default setting||As specified within the macro
|Dynamic specification||yes|| This parameter can only be specified dynamically. In the
parameter module, the macro
|Specification within session||no|
NTTAB1 table in
the alternative output translation table for the secondary character set used
when the profile/session parameter
=C is set.
The following topics are covered below:
TAB1 parameter is specified as
You specify pairs of characters, the first character of a pair being the character to be translated, the second character of a pair being the character into which the first character is to be translated.
You can specify each character either as the one-byte character itself (enclosed in apostrophes) or as the hexadecimal representation of that character.
TAB1=OFF all (static and dynamic) definitions are
reset to the values specified in the macro
NTTAB1 macro is specified as follows:
OFFcannot be specified with the macro
NTTAB1, but only dynamically with the profile parameter
TAB1 parameter, you must enclose the
entire string of character pairs in parentheses, for example:
In this example, the character represented by
'ö' into the character
H'78', the character represented by
H'FF' into the character represented by