This Natural profile parameter can be used to overwrite the definitions
in the translation table
NTTAB2 as contained in the
corresponds to the
macro in the Natural parameter module.
|Possible settings||See TAB2 Parameter Syntax.|
|Default setting||As specified within the macro
|Dynamic specification||yes|| This parameter can only be specified dynamically. In the
parameter module, the macro
|Specification within session||no|
NTTAB2 table in
the alternate input translation table for the secondary character set used when
the profile/session parameter
PM is set to
The following topics are covered below:
The TAB2 parameter is specified as follows:
You specify pairs of characters, the first character of a pair being the character to be translated, the second character of a pair being the character into which the first character is to be translated.
You can specify each character either as the one-byte character itself (enclosed in apostrophes) or as the hexadecimal representation of that character.
TAB2=OFF all (static and dynamic) definitions are
reset to the values specified in the macro
NTTAB2 macro is specified as follows:
OFFcannot be specified with the macro
NTTAB2, but only dynamically with the profile parameter
TAB2 parameter, you must enclose the
entire string of character pairs in parentheses, for example:
In this example, the character represented by
'ö' into the character
H'78', the character represented by
H'FF' into the character represented by
'ü' into 'Ü'.