This Natural profile parameter can be used to overwrite the definitions in the translation table NTTAB1 as contained in the configuration module NATCONFG. TAB1 corresponds to the NTTAB1 macro in the Natural parameter module.

Possible settings	See TAB1 Parameter Syntax.
Default setting	As specified within the macro NTTAB1 in NATCONFG.
Dynamic specification	yes	This parameter can only be specified dynamically. In the Natural parameter module, the macro NTTAB1 is used instead.
Specification within session	no

The following topics are covered below:

• TAB1 Parameter Syntax

• NTTAB1 Macro Syntax

• Example of TAB1 Parameter

• Example of NTTAB1 Macro

---

TAB1 Parameter Syntax

The TAB1 parameter is specified as follows:

TAB1=(a1,a2,b1,b2,c1,c2,...)

You specify pairs of characters, the first character of a pair being the character to be translated, the second character of a pair being the character into which the first character is to be translated.

You can specify each character either as the one-byte character itself (enclosed in apostrophes) or as the hexadecimal representation of that character.

Or:

TAB1=OFF

With TAB1=OFF all (static and dynamic) definitions are reset to the values specified in the macro NTTAB1 in NATCONFG.

NTTAB1 Macro Syntax

The NTTAB1 macro is specified as follows:

         NTTAB1 a1,a2,b1,b2,c1,c2,...

Notes:

1. For an explanation of the syntax elements, see TAB1 Parameter Syntax.
2. The value OFF cannot be specified with the macro NTTAB1, but only dynamically with the profile parameter TAB1.

Example of TAB1 Parameter

With the TAB1 parameter, you must enclose the entire string of character pairs in parentheses, for example:

TAB1=(5E,'Ä','ö',78,FF,00,'ü','Ü')

Example of NTTAB1 Macro

         NTTAB1 5E,'Ä','ö',78,FF,00,'ü','Ü'

In this example, the character represented by H'5E' is translated into 'Ä', 'ö' into the character represented by H'78', the character represented by H'FF' into the character represented by H'00', and 'ü' into 'Ü'.