This function is used to display in hexadecimal format the code of a Natural object currently loaded in the buffer pool.
To invoke
In the SYSBPM Main Menu, enter function code
H and specify an object: see the valid
field input values
as described in the section Invoking and Operating
SYSBPM.
Or:
Enter the following SYSPBM direct command:
DISPLAY HEX library-name object-name dbid fnr
The Hexadecimal Display screen appears with the object code displayed in hexadecimal format.
Within the object displayed on the screen, you can move to a specific location by entering either an absolute hexadecimal address or a hexadecimal offset relative to your current position.
On the Hexadecimal Display screen, you can use the PF keys or SYSBPM direct commands listed in the table below. An underlined portion of a command represents its minimum abbreviation. For further commands, see SYSBPM Direct Commands.
| PF Key | Command | Function |
|---|---|---|
| PF1 | Provides help information on SYSBPM direct commands. | |
| PF2 | NEXT |
Only applies if a range of objects was selected. |
| PF3 | EXIT |
Leaves the current function/screen and displays the previous screen. |
| PF4 | LAST |
Displays the SYSBPM direct command entered most recently. |
| PF6 | – |
Scrolls to the top of the display. |
| PF7 | - |
Scrolls up one page. |
| PF8 | + |
Scrolls down one page. |
| PF9 | ++ |
Scrolls to the end of the display. |
| PF12 |
CANCEL |
Same as EXIT.
|
| PF15 | MENU |
Invokes the SYSBPM Main Menu. |
NEXT |
Only applies if a range of objects was selected. |
