This Natural profile parameter allows you to overwrite the definitions in
the translation table NTTABL as contained in the
configuration module
NATCONFG. The
NTTABL table is used to translate output produced by
programs located in SYS... libraries.
TABL corresponds to the
NTTABL
macro in the Natural parameter module
NATPARM.
| Possible settings | See TABL Parameter Syntax below. | |
|---|---|---|
| Default setting | As specified within the macro
NTTABL in
NATCONFG.
|
|
| Dynamic specification | yes | This parameter can only be specified dynamically. In the Natural
parameter module NATPARM, the macro
NTTABL must be used instead.
|
| Specification within session | no |
The following topics are covered below:
The TABL parameter is specified as follows:
| TABL=(a1,a2,b1,b2,c1,c2,...) |
You specify pairs of characters, the first character of a pair being the character to be translated, the second character of a pair being the character into which the first character is to be translated.
You can specify each character either as the one-byte character itself (enclosed in apostrophes) or as the two-byte hexadecimal representation of that character.
The NTTABL macro is specified as follows:
| NTTABL a1,a2,b1,b2,c1,c2,... |
NTTABL 5E,'Ä','ö',78,FF,00,'ü','Ü'
In this example, the character represented by H'5E' is
translated into 'Ä', 'ö' into the character
represented by H'78', the character represented by
H'FF' into the character represented by H'00', and
'ü' into 'Ü'.
With the TABL parameter, you must enclose the
entire string of character pairs in parentheses, for example:
TABL=(5E,'Ä','ö',78,FF,00,'ü','Ü')
