This Natural profile parameter specifies the character to be used as the
command delimiter for the STACK parameter and for
command input under the Natural Development Server (product code: NDV) in a
Natural Single Point of Development environment.
To avoid that the value specified for the STACK
parameter or the data passed as command input under the Natural Development
Server is not interpreted as intended, the STACKD
parameter value should be set to a character that is not contained in the data
passed if the data contains the default value of the stack delimiter character
(see example below). The STACKD parameter should be
changed to a character other than the default character if the
ID parameter has been
set to the semicolon. For downward compatibility reansons, this restriction
does not apply to STACKD=; (the default setting).
| Possible settings | any special character | The character must not be the same as the one specified with the
ID profile/session
parameter (input delimiter character), DC profile/session parameter
(decimal character) or IA profile/session parameter
(input assign character).
|
|---|---|---|
| Default setting | ; (semicolon)
|
|
| Dynamic specification | yes | |
| Specification within session | no |
The character specified may be enclosed with single quotes. If the input
delimiter character is to be a comma, it must be specified as
ID=',', because the comma (,) separates individual parameters.
STACKD='/',ID=';' STACK=(DUMP IOB;+100/FIN)
To avoid that the semicolon after DUMP IOB is interpreted as
a command delimiter, STACKD is set to
'/'.
