This Natural profile parameter only applies to Natural under CICS, Com-plete, IMS TM and UTM.
It specifies the destination where output from an asynchronous application is to be displayed. The destination specified applies to hardcopy output and primary reports.
| Possible settings | 1 to 8 characters | Output destination, for example, printer. |
|---|---|---|
| Default setting | none | |
| Dynamic specification | yes | |
| Specification within session | no |
Any additional reports are sent to the destinations specified with the
DEFINE PRINTER
statement (just as in a synchronous online session).
The following platform-specific characteristics apply:
| Platform: | Comment: |
|---|---|
| CICS | The profile parameter SENDER specifies the
CICS transient data (TD) destination and the terminal or printer for terminal
output from asynchronous sessions. If the specified destination does not exist,
the session output is sent to the specified terminal or printer. If the
specified terminal or printer does not exist either, the session terminates
abnormally.
The default terminal output format for asynchronous sessions is a
3270 data stream. If the If you are routing all output to a (spool) destination, such as
CSSL, the Natural application must be switched to line mode, for example, by
specifying If you set With For further CICS-specific functionality, see Asynchronous Natural Processing under CICS in the TP Monitor Interfaces documentation. |
| Com-plete | See Asynchronous Natural Processing under Com-plete/SMARTS. |
| IMS TM | The profile parameter SENDER specifies the
default LTERM. This LTERM is always used when no
other printer has been specified. You should always dynamically define a
SENDER parameter in the NIIBOOT module.
This is important when Natural tries to output error messages when starting a
session: if no SENDER parameter is specified, there is
no valid LTERM and NATIMS terminates the
session.
|
| open UTM | The profile parameter SENDER specifies the
ID for the initialization of an asynchronous transaction; that is, the ID which
identifies the transaction as asynchronous. If output from an asynchronous
transaction is to be printed, the setting specified with the
SENDER parameter also identifies the printer on which
the output is to be printed.
For further open UTM-specific functionality, see Asynchronous Transaction Processing under UTM in the TP Monitor Interfaces documentation. |
For further information, see also the profile parameter
OUTDEST and
Asynchronous
Processing in the Operations documentation.
