The installation of Adabas Review for zIIP is basically the same as for Adabas Review. All ADARUN parameters that are available with Adabas Version 8.4 SP2 are valid except for those mentioned in Current Limitations in the Adabas for zIIP documentation. The only additional parameter provided for the support of Adabas for zIIP is the ZIIP parameter of the Adabas Review INPUT statement.

This document is organized as follows:

• Prerequisites

• License

• Installation Steps

---

Prerequisites

Prerequisite for Adabas Review for zIIP is a z13 or z14 mainframe with one or more zIIP engines, running z/OS 2.1 or above. Adabas Review for zIIP needs one zIIP engine to perform effectively.

License

Adabas Review that is to run zIIP-enabled requires an associated license file for zIIP support. This is the same license file required by the Adabas for zIIP (AZPAD) selectable unit for Adabas. If the AZPAD license is not provided or erroneous, the Adabas Review hub will run, but with the zIIP support deactivated (ZIIP=NO).

Alternatively or in addition, the license file can be referred to by a ‘DDLAZPAD’ DD statement in the Review Hub job or started task. This may be used as a fallback for the case that the AZPADLIC module cannot be loaded.

Installation Steps

Perform the following steps to install Adabas Review for zIIP

1. Set up one or more load libraries for your Adabas nuclei and utilities that are to be run with Adabas Review for zIIP.

2. Set up the required license modules or datasets.

3. Install the Adabas SVC from the AZP843.LOAD library.

4. Specify parameter ZIIP=YES in the RVUAUT1/RVUAUT2 data set in the INPUT statement.

5. Start the REVIEW.