These messages are written over the redisplayed SAGUSER batch control statements, starting in column 26, by the Software AG job exit utility (batch) for z/VSE systems.
SAGE020 | SAGE021 | SAGE022 | SAGE023 | SAGE024 | SAGE025| SAGE020 | - SAGIPT not found in the SDL |
| Explanation |
An entry for the phase SAGIPT was not found in the SDL. The SAGUSER control statements cannot be processed. |
| Action |
Verify that the phase SAGIPT was loaded into the SVA (using the SET SDL command). Load the phase if required, run the program SAGINST, and resubmit the job. |
| SAGE021 | - DD name table not found |
| Explanation |
The control table used by the job control exit cannot be found. The SAGUSER control statements cannot be processed. |
| Action |
Verify that the program SAGINST ran correctly. If not, rerun it and verify that one of the following messages is displayed: SAGI005, SAGI006, or SAGI016. |
| SAGE022 | - No room in DD name table |
| Explanation |
The control table used by the job control exit is full. The SAGUSER control statements cannot be processed. |
| Action |
Wait until some of the currently running jobs have completed and rerun the job that received the error message. |
| SAGE023 | - Invalid or missing FILE= |
| Explanation |
The SAGUSER control statement does not contain a "FILE=" parameter. The SAGUSER control statement cannot be processed. |
| Action |
Add the correct file designation to the control statement and rerun the job. |
| SAGE024 | - Invalid or missing MEMBER= |
| Explanation |
The SAGUSER control statement does not contain a "MEMBER=" parameter. The SAGUSER control statement cannot be processed. |
| Action: |
Add the correct member designation to the control statement and rerun the job. |
| SAGE025 | - Invalid SAGUSER control statement |
| Explanation |
The SAGUSER control statement does not contain any valid keyword parameters. The SAGUSER control statement cannot be processed. |
| Action |
Add the correct parameters to the control statement and rerun the job. |