Changing the Currently Defined Path of a Location
You can change the currently defined path of a location as follows:
To change the currently defined path of a location
1. Use a command of the following form:
inoadmin setlocation CentraSite <LocationType>
<path> [<path> ...]
where <LocationType> is one of the location types shown in the table above. The location can be assigned to more than one path. If several paths are defined, they are used in the order specified from left to right; when there is no more disk space available in a path, the next path is used.
If the path contains spaces or characters that the operating system treats as escape characters in the command line (for example, the backslash character \ in Windows), you must enclose the path in quotes.
The path or paths you specify completely replace the previously specified path or paths. If you want to extend the current path specification with an additional path, you need to use the inoadmin setlocation command and specify both the existing path and the new path.
The following example sets the new default path for the Backup location to C:\backuploc1 and D:\backuploc2. This means that C:\backuploc1 will be used as long as there is available disk space; if it is full, then D:\backuploc2 will be used instead.
inoadmin setlocation CentraSite backup C:\backuploc1 D:\backuploc2
Contact Support
|
Community
|
Feedback