Version 9.5 SP1
 —  Error Messages and Codes  —

Message Class ETBW - Broker Log and Console - Unit of Work/Persistence Messages

This page explains unit of work and persistence messages from the EntireX Broker Log and Console. These messages have the format:

ETBWnnnn

where ETBW is the message class, and
nnnn is the message number in the range 0000-9999

Overview of Messages

ETBW0138 | ETBW0145 | ETBW0313 | ETBW0314 | ETBW0317 | ETBW0318 | ETBW0330 | ETBW0331 | ETBW0332 | ETBW0333 | ETBW0334 | ETBW0349 | ETBW0354 | ETBW0426 | ETBW0429 | ETBW0506 | ETBW0517 | ETBW0521 | ETBW0526 | ETBW0535 | ETBW0536 | ETBW0537 | ETBW0545 | ETBW0595 | ETBW0607 | ETBW0616 | ETBW0618 | ETBW0640 | ETBW0663 | ETBW0684

ETBW0138 PSI: Maximum Extents used for Cell Pool
Explanation

The Broker detected that the persistent store has no more cells available for cell pool xxxxxxxx (see diagnostic message ETBD0286 next to additional info for the name of the cell pool) and the maximum number of extents have been reached.

Action

Review the persistent store startup parameters and increase the initial allocation value for the exhausted cell pool. For the new value to take effect, you must cold start the persistent store and restart the Broker.


ETBW0145 PSI: Attempt to expand beyond Dataspace Boundary
Explanation

The Broker attempted to expand the persistent store beyond the dataspace boundary.

Action

Review the persistent store startup parameter for dataspace pages and increase accordingly to an appropriate value. Restart the Broker. Use the System Management Hub to monitor usage in the persistent store.


ETBW0313 Broker RESTART failed
Explanation

During broker startup, an error has been detected during the restart processing phase.

Action

Examine the EntireX Broker log. Determine the cause of the error. Correct the error and restart the Broker. If the cause cannot be determined, contact Software AG support.


ETBW0314 API: UOW status invalid
Explanation

The unit of work status code is not a recognized value.

Action

This is probably an internal EntireX Broker error. Contact Software AG support.


ETBW0317 PSI: Persistent Store termination failed
Explanation

An attempt to shut down the persistent store failed.

Action

None.


ETBW0318 PSI: Function input parms invalid
Explanation

The requested persistent store function is not supported by the PSTORE handler. The request is ignored.

Action

Contact Software AG support.


ETBW0330 PSI: Restart-Temp Msg File Open Failed
Explanation

This is an internal error.

Action

Contact Software AG support.


ETBW0331 PSI: Restart-Temp Msg IDX Open Failed
Explanation

This is an internal error.

Action

Contact Software AG support.


ETBW0332 PSI: Restart-Msg Index Length Zero
Explanation

This is an internal error.

Action

Contact Software AG support.


ETBW0333 PSI: Restart-Msg File Read Failure
Explanation

This is an internal error.

Action

Contact Software AG support.


ETBW0334 PSI: Restart-Temp Msg File Write Failure
Explanation

This is an internal error.

Action

Contact Software AG support.


ETBW0349 Publish and Subscribe is not licensed
Explanation

Make sure that your license file contains entries that allow you to use the Publish and Subscribe feature.

Action

Contact Software AG support.


ETBW0354 EntireX License Key Error
Explanation

Your EntireX License has expired.

Action

Please contact your local Software AG office or distributor to extend your license.


ETBW0426 Start of ETB_SHUTDOWN thread failed
Explanation

UNIX/Windows only. The "etbnuc" process encountered an error while creating shutdown thread. Broker could not be initialized.

Action

Contact Software AG support.


ETBW0429 Missing or invalid XTI library
Explanation

One of the components of Entire Net-Work communicator is missing.

Action

Contact Software AG support.


ETBW0506 ** Communicator not available anymore **
Explanation

The Communication Manager of the transport layer stops due to unrecoverable errors, exceeded retry limit or shutdown.

Action

Check the log file for error messages. Ignore this warning if shutdown was requested.


ETBW0517 Terminate Restart Handling
Explanation

The Communication Manager did not succeed to run the transport-specific Communicator. All attempts to restart the Communicator were not successful.

Action

Check the log file for error messages.


ETBW0521 Unexpected Communicator Nucleus Status
Explanation

A component of the transport layer detected an unexpected status and will stop immediately.

Action

Check the log file for error messages or shutdown.


ETBW0526 Broker kernel not running with Security
Explanation

An operator command was issued that interacts with Broker's security component. However, security was not activated for this Broker.

Action

Do not issue security relevant operator commands without activating security.


ETBW0535 PSTORE is not licensed
Explanation

Make sure that your license file contains entries that allow you to use the persistent store for the Publish/Subscribe feature.

Action

Contact Software AG support.


ETBW0536 SUBSCRIBER-STORE is disabled
Explanation

The subscriber store is configured to use the primary store, and the primary store is not licensed.

Action

Contact Software AG support.


ETBW0537 Ambiguous: CONVERSION and TRANS
Explanation

Broker detected that attributes of the indicated service (or topic) specify both TRANSLATION and CONVERSION parameters. Broker ignores the TRANSLATION parameter and continues with initialization.

Action

If you still want the service (or topic) to use TRANSLATION only, edit the Broker attribute file and delete the line containing CONVERSION= for this service (or topic) in DEFAULTS=SERVICE or DEFAULTS=TOPIC.


ETBW0545 EntireX License Status License expiration date is yyyy/mm/dd . License will expire in nn days - or - License expired on yyyy/mm/dd
Explanation

Indicates the expiration date of your EntireX license. If the expiration date is less than 30 days in the future but greater than 0, you are reminded to contact Software AG. If the license has expired, you will not be able to restart.

Action

Please contact your local Software AG office or distributor to extend your license.


ETBW0595 PSILIB: PSTORE-TYPE=FILE is unsupported
Explanation

PSTORE-TYPE=FILE is no longer supported.

Action

Migrate the data of the persistent store of type file to a different persistent store type. See Migrating the Persistent Store.


ETBW0607 Command logging switched off
Explanation

Command logging was requested. However, it is not possible to switch on command logging due to configuration errors.

Action

Fix the problem and switch on command logging.


ETBW0616 CPU limit reached
Explanation

The CPU time of the task is exceeded. Broker received the interrupt from the operating system and will go down.

Action

Specify a TIME=1440 parameter for the JCL EXEC statement of the Broker to run Broker without CPU limit.


ETBW0618 Transport not active
Explanation

The transport-specific operator command cannot be executed. The transport is currently not active.

Action

Issue the operator command when the transport is active.


ETBW0640 EntireX License Key Warning
Explanation

A warning occurred while processing the EntireX License file. Additional error test will provide more information.

Action

Consult the additional error text and take appropriate action.


ETBW0663 No assignment for LICENSE Report
Explanation

Under z/OS and BS2000/OSD, the license is printed during startup. However, the assignment for the license report output file is missing.

Action

Assign the license report output file.


ETBW0684 Cannot make Broker non-swappable
Explanation

Broker not APF-authorized.

Action

Ensure that all load libraries in the Broker kernel steplib are APF-authorized.


Top of page