Universal Messaging 9.12 | Administration Guide | Universal Messaging Enterprise Manager | Administration Using Enterprise Manager | Cluster Administration | Creating and Managing Clusters with Sites
 
Creating and Managing Clusters with Sites
This section describes the process of modifying a Universal Messaging Cluster into a Universal Messaging Cluster with Sites. Clusters with Sites allow a standard Universal Messaging Cluster to operate with as little as 50% of the active cluster members, and provides administrators with a mechanism to prevent the split brain scenario that would otherwise be introduced when using exactly half of a cluster's realms.
Viewing Site Information in Enterprise Manager
The Enterprise Manager's top level view shows a tree node labelled "Universal Messaging Enterprise" (see Enterprise Summary). One level below this is a tree node labelled "Clusters", which contains any known clusters.
After creating your cluster (see Creating a Cluster) and selecting the cluster's icon in the Enterprise Manager, click the Sites tab:
Sites Tab in Cluster View. No Sites have yet been created for the above cluster.
Creating a Primary Site for a Cluster
Click the New button to create the first Site. We'll assume the site is named Production. Follow the prompts and pick a Realm to include in the site, for example realm1:
Creation of a "Production" Site.
Addition of an Initial Member to "Production" Site.
At this point, the new Site will appear in the Sites tab:
The "Production" Site with its initial member realm is shown.
Note that the table will contain a column for all realms in the cluster. In this example we have only added one realm to the Production Site. Checking and unchecking the appropriate checkboxes will add or remove clustered realms from the corresponding Sites.
Creating a Backup Site for a Cluster
Next, follow the same steps to create the second Site, which in this example we shall assume is named : Disaster Recovery
Creation of a "Disaster Recovery" Site and addition of an initial site member realm.
Addition of an Initial Member to "Disaster Recovery" Site.
The new Disaster Recovery Site will now also appear in the Sites tab:
Sites Tab in Cluster View. The "Production" and "Disaster Recovery" Sites are both shown.
Setting a Site's IsPrime Flag
Administrators use the Sites isPrime flag to determine which site will contain a cluster's Master realm. Typically, the Disaster Recovery Site will be set to be Prime, allowing the Production site to fully fail and allowing the Disaster Recovery Site to vote a new master. Should the Disaster Recovery Site fail, the administrators would set the Production Site to be Prime, which permits the election of a new Master without the usual 51% quorum requirement:
Setting the Disaster Recovery Site to be Prime by checking its isPrime checkbox.

Copyright © 2013-2019 | Software AG, Darmstadt, Germany and/or Software AG USA, Inc., Reston, VA, USA, and/or its subsidiaries and/or its affiliates and/or their licensors.