Universal Messaging 9.12 | Administration Guide | Using Command Central to Manage Universal Messaging | Universal Messaging Configuration Types | Ports Configuration | Port Configuration Attributes | Basic Port Connection Attributes
 
Basic Port Connection Attributes
The table describes the basic connection attributes of a port.
Configure this...
To specify...
Port Type
The port (interface) should use one of the following protocols:
*Creating a connection factory and destination with the same name is not allowed for a Universal Messaging server instance.
*Socket protocol (nsp)
*HTTP protocol (nhp)
*HTTPS protocol (nhps)
*SSL protocol (nsps)
You cannot change this attribute after you create the port.
Port Number
The number of the port.
You cannot change this attribute after you create the port.
Bind Address
The IP address to which to bind this port, if your machine has multiple IP addresses and you want the port to use this specific address.
You cannot change this attribute after you create the port.
Backlog
The maximum size of the IP socket queue. When the incoming socket request queue reaches this maximum value, the incoming connection requests are refused. The requests will be serviced only when the queue size is less than the maximum size.
Enabled
Whether the port is enabled or disabled.
Note: If Command Central fails to enable a port, check the Universal Messaging logs to find out the reason for failure.
Copyright © 2013-2019 | Software AG, Darmstadt, Germany and/or Software AG USA, Inc., Reston, VA, USA, and/or its subsidiaries and/or its affiliates and/or their licensors.