mft.gatewayServer.
This section describes the parameters you can configure for
ActiveTransfer Gateway, in the properties configuration file on the Gateway. For more information about
ActiveTransfer Gateway configuration, see
Managing
ActiveTransfer Gateway .
mft.gatewayServer.port
Specifies the default registration port for ActiveTransfer Gateway. This value is used when an ActiveTransfer Gateway is configured on the Gateway tab of the Server Management page. The default is 8500.
When ActiveTransfer Gateway runs on a port (for example, 8500), the Gateway uses the next numbered port (for example, 8501) as the data port. Therefore, when you configure the registration port, make sure the next port on the machine is also available.
mft.gatewayServer.accept.ip.list
Specifies a list of IP addresses, separated by commas, representing the ActiveTransfer Servers that ActiveTransfer Gateway should accept connections from. When the Gateway is started, only the ActiveTransfer Servers running on these IP addresses can connect to the Gateway. The default is blank, which means ActiveTransfer Gateway accepts connections from any ActiveTransfer Server.
Note: | If no value is set for this property, the Gateway denies connections to ActiveTransfer Servers with IP addresses on a different subnet mask than the ones that are already connected to the Gateway. To avoid this issue, include this parameter in the properties.cnf file with the IP addresses of the servers on different subnet masks separated by commas. |
mft.gateway.is.external.port
Specifies the external port configured for the Enterprise Gateway Server.
mft.gateway.ping.interval
Specifies the interval (in seconds) at which the ActiveTransfer Gateway will ping the ActiveTransfer Server to check if the server is running.
mft.gateway.ping.retry.count
Specifies the number of failed pings after which the ActiveTransfer Gateway ports will be disabled. Set this property to 0 if you want the ports to be disabled on first failure.
Contact Support
|
Community
|
Feedback