Load Balancing Configuration
If you cluster Mediator instances, you must configure Mediator with the load balancer URL appropriately for Mediator to report the virtual service address at the load balancer URL instead of having direct access address withMediator. You can use either HTTP or HTTPS protocols for load balancing.
To configure load balancer URLs
1. Open the Integration Server Administrator if it is not already open.
2. In the Navigation panel, select Solutions > Mediator > Administration > General.
3. On the Mediator Configuration screen, click Edit.
4. Under HTTP Config, set the parameters as follows:
For this parameter... | Specify... |
Load Balancer URL (HTTP) | The primary HTTP load balancer URL and port number to use. For the URL, you can specify either the IP address or host name of the load balancer with the port number, as follows: http://IP-address:portnumber or http://hostname:portnumber If specified, all the virtual services hosted in Mediator uses this value. |
Load Balancer URL (HTTPS) | The primary HTTPS load balancer URL and port number to use. For the URL, you can specify either the IP address or host name of the load balancer with the port number, as follows: https://IP-address:portnumber or https://hostname:portnumber If specified, all the virtual services hosted in Mediator (and exposed on HTTPS) uses this value. Note: | The SSL connection is dropped if the remote server hosting the service is not trusted by Integration Server. To avoid this, you must create an Integration Server truststore and select it as part of the keystore configuration. For information about configuring a truststore for Integration Server, see webMethods Integration Server Administrator’s Guide. For information about selecting the truststore as part of the Mediator configuration, see Configuring Keystore. |
|
5. Click Save.
Your changes take effect immediately.
Contact Support
|
Community
|
Feedback