Setting and Removing Breakpoints on Flow Step

Service Development Help : Debugging Flow Services : Using Breakpoints When Debugging Flow Services : Setting and Removing Breakpoints on Flow Step

You can set or remove a breakpoint on a flow step by toggling the breakpoint. During debugging, processing will halt immediately before this flow step.

To toggle a breakpoint on a flow step

Open the flow service in which you want to set a breakpoint and do one of the following:

On the Tree tab, right-click the step at which you want to set the breakpoint and select Toggle Breakpoint. Designer displays or removes

in the vertical margin next to the flow step.

On the Tree tab, right-click in the vertical margin next to the flow step at which you want to set a breakpoint and select Toggle Breakpoint. Alternatively, double-click in the margin next to the flow step. Designer displays

or removes in the vertical margin next to the flow step.

On the Layout tab, double-click the connection line in front of the flow step at which you want to set a breakpoint and select Toggle Breakpoint. Designer displays

or removes right before the flow step.

On the Layout tab, select the connection line in front of the flow step at which you want to set a breakpoint. Right-click and select Toggle Breakpoint. Designer displays

or removes right before the flow step.

Note:

You can also use Breakpoints view to remove breakpoints or select Run > Remove All Breakpoints.

Contact Support | Community | Feedback