Specifying the Quiesce Port
Before you can start or restart an Integration Server in quiesce mode for the first time, you must specify the port through which the server will enter and exit quiesce mode. This port and the diagnostic port are the only ports that remain enabled when a server enters quiesce mode. You cannot disable the quiesce port or the diagnostic port when the server is in quiesce mode.
Note: | The quiesce port must reside in either the WmRoot or the WmPublic package. The port must also be enabled and have “allow” or “allow+” privilege. If the quiesce port is not specified, is suspended or disabled, or does not have “allow” or “allow+” privileges, Integration Server will not be able to enter quiesce mode. |
To specify the quiesce port
1. Open the Integration Server Administrator if it is not already open.
2. In the Settings menu of the Navigation panel, click Quiesce.
3. From the Select New Quiesce Port list, select the port you want Integration Server to use as the quiesce port.
Note: | This list does not include the diagnostic port or any HTTP/HTTPS ports created for Internal Servers in a webMethods Enterprise Gateway configuration. |
4. Click Save Changes.
Contact Support
|
Community
|
Feedback