Administering Mediator : Mediator Configurations : SNMP Destinations for Run-Time Events : Setting Mediator to Use a Third-Party SNMP Server : Setting Mediator to Use a Third-Party SNMP Server (SNMP v3 User-Based Security Model)
Setting Mediator to Use a Third-Party SNMP Server (SNMP v3 User-Based Security Model)
To set Mediator to use the SNMP v3 user-based security model
1. Open the Integration Server Administrator if it is not already open.
2. In the Navigation panel, select Solutions > Mediator > Administration > SNMP.
3. On the SNMP Configuration screen, click Edit.
4. Under 3rd Party SNMP Configuration, mark the Send TRAPs to 3rd party SNMP Server check box.
5. For SNMP Target Type, click User.
6. Set the 3rd Party SNMP Configuration parameters as follows:
For this parameter...
Specify...
Host Name/IP Address
The SNMP server's exact IP address that is specified in CentraSite or a hostname that resolves to that IP address. The host name cannot be localhost or the loopback (127.0.0.1).
Port
The SNMP trap receiver port that is listening for SNMP requests and packets.
Transport
The protocol used by SNMP to send traps. Valid values are TCP (default) and UDP.
User Name
The SNMPv3 user name to use when connecting to the receiver.
Use Authorization (optional)
Specifies whether an authorization key is required. It is set to off by default. You cannot edit the authorization fields unless Use Authorization is selected.
Authorization Password / Retype Authorization Password
The key to be used for authorization. This must also be configured on the SNMP server.
Authorization Protocol
The authorization protocol to use. Valid values are MD5 (default) or SHA
Use Privacy (optional)
Whether a privacy (encryption) key is required. It is set to off by default. You cannot edit the privacy fields unless Use Privacy is selected.
Privacy Password
The key to be used for privacy.
Retype Privacy Password
The same password you entered in the Privacy Password field to verify that you entered it correctly.
Privacy Protocol
The privacy protocol to use. Valid values are DES (default), AES128, AES192, and AES256.
7. Click Save.
Your changes take effect immediately.
Note:  
Additional parameters are available in the Mediator properties file, see the sections pg.snmp.userTarget and pg.snmp.customTarget in Advanced Settings and Server Configuration Parameters.
Copyright © 2015- 2017 Software AG, Darmstadt, Germany. (Innovation Release)
Product LogoContact Support   |   Community   |   Feedback