Administering Mediator : Mediator Configurations : SNMP Destinations for Run-Time Events : Setting Mediator to Use a Third-Party SNMP Server : Setting Mediator to Use a Third-Party SNMP Server (SNMP v1 Community-Based Security Model)
Setting Mediator to Use a Third-Party SNMP Server (SNMP v1 Community-Based Security Model)
To set Mediator to use the SNMP v1 community-based security model
1. Open the Integration Server Administrator if it is not already open.
2. In the Navigation panel, select Solutions > Mediator > Administration > SNMP.
3. On the SNMP Configuration screen, click Edit.
4. Under 3rd Party SNMP Configuration, mark the Send TRAPs to 3rd party SNMP Server check box.
5. For SNMP Target Type, click Community.
6. Provide the following information:
For this parameter...
Specify...
Host Name/IP Address
The name or IP address of the third-party SNMP server. The host name cannot be localhost.
Port
The SNMP trap receiver port that is listening for SNMP requests and packets. The default is 2162.
Transport
The protocol used by SNMP to send traps. Valid values are TCP (default) and UDP.
If you select UDP, ensure that the SNMP server is in the same subnet, or else configure the routers to get packets across subnet boundaries. The maximum PDU size when running in UDP mode is 64Kb which might be restrictive when sending large request and response payloads for Transaction Events.
Community Name
The community name to be used to interact with the SNMP receiver. This value must match the value that you set in the SNMP receiver. The default is public.
7. Click Save.
Your changes take effect immediately.
Note:  
Additional parameters are available in the Mediator properties file, see the sections pg.snmp.communityTarget and pg.snmp.customTarget in Advanced Settings and Server Configuration Parameters.
Copyright © 2015- 2017 Software AG, Darmstadt, Germany. (Innovation Release)
Product LogoContact Support   |   Community   |   Feedback