Allow Inbound Requests from Specified Hosts (Deny All Others)
The following procedure describes how to change the IP access settings for an individual port to Allow by Default and deny some hosts.
With this setting in effect, the server denies most hosts and allows some through this port.
Important:
Before you switch your global setting to Deny by Default, make sure you have at least one port that does not rely on the global setting and allows at least one host. If you inadvertently lock all hosts out of the server, you can correct the problem by manually updating the appropriate configuration file. See
If You Inadvertently Deny IP Access
to All Hosts for instructions.
To allow inbound requests from only specified hosts
1. Open the Integration Server Administrator if it is not already open.
2. Go to Security > Ports.
3. Locate the port in the Port List and click the Allow or Deny link in the IP Access column.
4. Click Change IP Access Mode to Deny by Default.
The server changes the access mode and displays a page from which you can add hosts to the Allow List. Notice that the server has already included the host name and IP address of the machine from which you are using the Integration Server Administrator so that you are not locked out of the server.
5. Click Add Hosts to Allow List.
6. Specify the host names or IP addresses of clients from which the server is to accept inbound requests (e.g., workstation5.webmethods.com). Separate your entries with commas, for example: *.allowme.com, *.allowme2.com.
The host names or IP addresses can include upper and lower case alphabetic characters, digits (0-9), hyphens (-), and periods (.) and cannot include spaces. For IPv6, IP addresses can also include colons (:) and brackets ([]).
Avoid using the fully qualified domain name of the host. Integration Server resolves incoming host names to the simple host name and then compares the simple host name to the fully qualified domain name in the allow list. The names will not match and Integration Server will conclude that the request should be denied. To work around this, you can use the * wildcard at the end of the simple host name. Alternatively, use the IP address.
You can use the following pattern-matching characters to identify several clients with similar host names or IP addresses.
Char | Description | Example |
* | Matches any number of characters | r*.webmethods.com |
? | Matches any single character | workstation?.webmethods.com |
7. Click Add Hosts.