ClearCase Configuration
Complete the following procedure for each Integration Server user that will use ClearCase.
To configure ClearCase for use with an
Integration Server user
1. If the user is on a UNIX system, identify the ClearCase command binaries to the system. To the PATH variable, add the fully qualified path to the ClearCase folder that contains the binary files for commands.
2. If the user is on a Windows system identify the ClearCase command binaries to the system as follows:
a. Right click My Computer and then click Properties.
b. Click the Advanced tab and then click Environment Variables.
c. In the System Variables table, to the Path variable, add the fully qualified path to the ClearCase folder that contains the binary files for commands.
Note:
These files are usually present by default. However, if they are not present, you must add them.
d. Click OK three times.
Note:
These instructions are for Windows XP Professional. Instructions for other Windows systems might vary slightly.
3. If the user is on a Windows system configure ClearCase Dynamic Views to work with the VCS Integration feature as follows:
a. On the Start menu, go to Settings > Control Panel > ClearCase.
b. Click the MVFS tab.
c. Select the check boxes for Case Insensitive MVFS and Case Preserving.
d. Click OK.