Using the XML Mapping Editor in Command-line Mode


Command-line Options

See Using EntireX in the Designer Command-line Mode for the general command-line syntax. The table below shows the command-line options for the XML Mapping Editor.

Task Command Option Description
Create SOAP-conformant XML mapping for all programs. -map:soap    
-map:soap1.1   Supported for compatibility with older versions.
Create attribute-preferred XML mapping for all programs. -map:xmlattributes    
Create element-preferred XML mapping for all programs. -map:xmlelements    
Create element-preferred XML mapping with XML Schema for all programs -map:xmlwithxsd -namespace If namespace is specified, the namespace URI for the program node. XML Schema uses this namespace URI as the target namespace.
Create sample XML documents for all programs. -xml:sample    

Example

<workbench> -map:soap /Demo/example.idl

where <workbench> is a placeholder for the actual EntireX design-time starter as described under Using EntireX in the Designer Command-line Mode.

The generated XML mapping file (XMM) will be stored in parallel to the IDL file, for example in project Demo.

Status and processing messages are written to standard output (stdout), which is normally set to the executing shell window.