The Web Services Wrapper generates a WSDL file, a mapping file (extension .xmm) and a service archive (extension .aar) to deploy into the common Web Services Stack. This section covers the following topics:
See Using EntireX in the Designer Command-line Mode for the general command-line syntax. The table below shows the command-line option for the Web Services Wrapper.
Task | Command | Option | Description |
---|---|---|---|
Generate WSDL, mapping and archive files from specified IDL file. | -wsdl |
-out |
Output directory, absolute path (fully qualified, must exist). Ignored if the
input is part of a project in the Eclipse workspace. Same as
-o .
|
-url |
Service URL. Same as -u .
|
||
-service=<service> |
Service name. | ||
-properties |
Use the file-specific properties. This option makes the others superfluous, but is only available if the input is part of an Eclipse project. |
<workbench> -wsdl /Demo/example.idl -properties
where <workbench>
is a placeholder for the actual
EntireX design-time starter as described under Using EntireX in the Designer Command-line Mode.
The name of the IDL file includes the project name. In the example, the project Demo is used. If the IDL file name describes a file within the Eclipse workspace, the name is case-sensitive.
If the first part of the IDL file name is not a project name in the current workspace, the IDL file name is used as a relative (based on the IDL file) or absolute file name in the file system. Thus, the IDL files do not need to be part of an Eclipse project.
The generated mapping file gets the name of the IDL file. The WSDL file and the service archive get the name of the service, if specified, otherwise they get the name of the IDL file.
<workbench> -wsdl /Demo/example.xmm -properties
This command generates the WSDL file and the service archive from the mapping file. If a service name is specified, the WSDL file and the service file get the name of the service, otherwise they get the name of the mapping file.
Status and processing messages are written to standard output (stdout), which is normally set to the executing shell window.
<workbench> -wsdl C:\Temp\example.idl
Uses the IDL file C:\Temp\example.idl and generates the files (EXAMPLE.wsdl and example.xmm) in parallel to the IDL file. Slashes and backslashes are permitted in the file name. Output to standard output:
Using workspace file:/C:/myWorkspace/. LIBRARY = EXAMPLE Program = CALC Program = SQUARE WSDL file "C:\Temp\EXAMPLE.wsdl" created. Exit value: 0
<workbench> -wsdl -help
or
<workbench> -help -wsdl
Both show a short help for the Web Services Wrapper.
<workbench> -wsdl /Demo/example.idl
If the project Demo exists in the workspace and example.idl exists in this project, this file is used. Otherwise, /Demo/example.idl is used from file system. The generated output (EXAMPLE.wsdl and example.xmm) will be stored in /Demo, parallel to the IDL file.
<workbench> -wsdl -help
or
<workbench> -help -wsdl
Both show a short help for the Web Services Wrapper.