EntireX Broker includes a stub that supports both the TCP/IP and ADALNK transports and can be used with non-Natural applications in TSO or Batch mode. The SAGTOKEN module that is included allows you to set, delete, or display (locally or globally) variables that are used to:
Set the stublog number, which is used to control tracing.
Specify which transport is preferred: TCP-NET means use TCP/IP if possible. NET-TCP means use Entire Net-Work if possible.
The messages described in this section are generated by the SAGTOKEN module and displayed at the operator console.
SAGTOK01 | SAGTOK02 | SAGTOK03 | SAGTOK04 | SAGTOK05 | SAGTOK06 | SAGTOK07
SAGTOK01 | Token xxxxxxxxxxxx set to nnnnnnnnnnnnnnn |
Explanation |
The identified token has been set to the value shown. |
Action |
This message is informational only. |
SAGTOK02 | Token Services Error xxxxxxxx Returned |
Explanation |
The identified IBM Token Services error has been returned. |
Action |
Refer to the appropriate IBM documentation. |
SAGTOK03 | Invalid Command to Token Services |
Explanation |
An invalid |
Action |
Check the command syntax and correct the error. |
SAGTOK04 | Token Keyword Exceeds Maximum Length of 12 |
Explanation |
|
Action |
Check the keyword specification and correct the error. |
SAGTOK05 | Not Properly Authorized for Token Services |
Explanation |
|
Action |
Verify that all libraries in the STEPLIB concatenation are properly authorized. |
SAGTOK06 | Command Exceeds Maximum Length of 80 Characters |
Explanation |
Command can be no longer that 80 characters. |
Action |
Shorten the command to 80 or less characters and rerun the SAGTOKEN program. |
SAGTOK07 | Invalid Delimiter between operand 2 and 3 |
Explanation |
The delimiter between the second operand and the third operand was not a comma. |
Action |
Change the command to use a comma as the delimiter after the second operand and rerun the SAGTOKEN program. |