Deployer 10.7 | Introduction to webMethods Deployer | Logging | Enabling or Disabling Audit Logging for the Deployer User Interface
 
Enabling or Disabling Audit Logging for the Deployer User Interface
In Deployer, go to Settings > Audit Logging Settings and specify whether to enable or disable audit logging for user actions taken through the Deployer user interface.
To view the audit log, from the Integration Server Administrator go to the Logs > Audit page. The following table describes the columns in the audit log.
Column
Description
Time Stamp
Date and time the entry was written to the log.
Request Type
Type of action Deployer performed (for example, Create, Build, or Deploy).
Message
Message that describes the action.
Status
Outcome of the action (for example, Success or Failed).
User Id
User name under which Deployer performed the action.
Server
Details about the server. See Type, Alias, and Host IP:Port.
Type
Type of server on which the action was performed; can include the Integration Server that hosts Deployer and source and target servers.
Alias
Name assigned to the server in Deployer.
Host IP:Port
IP address and port for the server on which the action was performed.
Thread ID
Unique identification for each Deployer action. If an action fails, the thread ID helps you identify the failed action through the Audit Log page in Deployer. Using this, the user can identify the failed activity.
To change this display, use the Log display controls area at the top of the page and then click Refresh. The changes remain until you change them again, or until you shut down the Integration Server that hosts Deployer, whichever comes first.