Two-Way/Push-Pull
This MEP is used to push a request user message to a trading partner followed by a pull signal to receive a reply user message as shown in the diagram. Both the user message and the pull signal are sent by the initiating MSH.
The pulled user message refers to the user message that was pushed.
Steps | Description |
1 | The initiating MSH sends a user message to the responding MSH. |
2 | The initiating MSH sends a pull signal to the responding MSH. |
3 | A user message is submitted at the responding MSH as a response to the request user message. |
For more information about configuring the module to use the Two-Way/Push-Pull MEP, see
Configuring Trading Partner
Agreements. For more information about built-in service, see
Built-In Services.
Important:
When purging the transaction analysis in Trading Networks, do not delete user messages in the QUEUED state.
Whenever you purge the transaction analysis, use the wm.ip.estd.as4:clearMPC service to manually clear all the BizDocIds that are queued in the cache.