Duplicating a block
You can duplicate each block that is currently shown on the canvas. The original block and its copy will then both have the same parameters.
When you duplicate a single block, the attached wires are not automatically duplicated. When you duplicate several blocks at the same time, however, the attached wires between the selected blocks are automatically duplicated.
To duplicate a block
On the canvas of the model editor, click the block that you want to duplicate and then do one of the following: Click the
Duplicate command which is shown at the bottom of the block parameter editor.
Or press Ctrl+C to copy the block, and then press Ctrl+V to paste the block.
Or press Ctrl and drag the block to be duplicated to the position at which you want to place the copy.
Or to duplicate several blocks at the same time, select them as described in
Selecting blocks and wires and then proceed as described above. Exception: the Duplicate command is only available when you select a single block.