Apama Analytics Builder for Cumulocity IoT 10.5 | Apama Analytics Builder for Cumulocity IoT Documentation | Using Apama Analytics Builder for Cumulocity IoT | Using the Model Editor | Working with blocks and wires | Duplicating a block
 
Duplicating a block
You can duplicate each block that is currently shown on the canvas. The original block and its copy will then both have the same parameters.
When you duplicate a single block, the attached wires are not automatically duplicated. When you duplicate several blocks at the same time, however, the attached wires between the selected blocks are automatically duplicated.
* To duplicate a block
*On the canvas of the model editor, click the block that you want to duplicate and then do one of the following:
*Click the Duplicate command which is shown at the bottom of the block parameter editor.
*Or press Ctrl+C to copy the block, and then press Ctrl+V to paste the block.
*Or press Ctrl and drag the block to be duplicated to the position at which you want to place the copy.
*Or to duplicate several blocks at the same time, select them as described in Selecting blocks and wires and then proceed as described above. Exception: the Duplicate command is only available when you select a single block.

Copyright © 2018-2019 | Software AG, Darmstadt, Germany and/or Software AG USA, Inc., Reston, VA, USA, and/or its subsidiaries and/or its affiliates and/or their licensors.