Apama Analytics Builder 10.5.7 | Using Apama Analytics Builder for Cumulocity IoT | Using the Model Editor | Working with blocks and wires | Duplicating a block
 
Duplicating a block
You can duplicate each block that is currently shown on the canvas. The original block and its copy will then both have the same parameters.
When you duplicate a single block, the attached wires are not automatically duplicated. When you duplicate several blocks at the same time, however, the attached wires between the selected blocks are automatically duplicated.
*To duplicate a block
*On the canvas of the model editor, click the block that you want to duplicate and then do one of the following:
*Click the Duplicate command which is shown at the bottom of the block parameter editor.
*Or press Ctrl+C to copy the block, and then press Ctrl+V to paste the block.
*Or press Ctrl and drag the block to be duplicated to the position at which you want to place the copy.
*Or to duplicate several blocks at the same time, select them as described in Selecting blocks and wires and then proceed as described above. Exception: the Duplicate command is only available when you select a single block.