This Natural profile parameter can be used to overwrite the definitions
in the translation table NTTAB2 as contained in the
configuration module
NATCONFG. TAB2
corresponds to the NTTAB2
macro in the Natural parameter module.
| Possible settings | See TAB2 Parameter Syntax. | |
|---|---|---|
| Default setting | As specified within the macro
NTTAB2 in NATCONFG.
|
|
| Dynamic specification | yes | This parameter can only be specified dynamically. In the
Natural
parameter module, the macro NTTAB2 is used
instead.
|
| Specification within session | no | |
Note:
The NTTAB2 table in NATCONFG is
the alternate input translation table for the secondary character set used when
the profile/session parameter PM is set to
PM=C.
The following topics are covered below:
The TAB2 parameter is specified as follows:
| TAB2=(a1,a2,b1,b2,c1,c2,...) |
You specify pairs of characters, the first character of a pair being the character to be translated, the second character of a pair being the character into which the first character is to be translated.
You can specify each character either as the one-byte character itself (enclosed in apostrophes) or as the hexadecimal representation of that character.
Or:
| TAB2=OFF |
With TAB2=OFF all (static and dynamic) definitions are
reset to the values specified in the macro NTTAB1 in
NATCONFG.
The NTTAB2 macro is specified as follows:
NTTAB2 a1,a2,b1,b2,c1,c2,...
Notes:
OFF cannot be specified with the macro
NTTAB2, but only dynamically with the profile parameter
TAB2.
With the TAB2 parameter, you must enclose the
entire string of character pairs in parentheses, for example:
TAB2=(5E,'Ä','ö',78,FF,00,'ü','Ü')
NTTAB2 5E,'Ä','ö',78,FF,00,'ü','Ü'
In this example, the character represented by H'5E' is
translated into 'Ä', 'ö' into the character
represented by H'78', the character represented by
H'FF' into the character represented by H'00', and
'ü' into 'Ü'.