
Natural for Mainframes	Version 8.2.6 for Mainframes	SEARCH CONTENTS \| PDF BOOKS \| HOME UP PREV NEXT

— Parameter Reference —

SCTAB - Scanner Characters

This Natural profile parameter can be used to overwrite the definitions in the scanner character-type table NTSCTAB, which is contained in the configuration module NATCONFG. SCTAB corresponds to the NTSCTAB macro in the Natural parameter module.

Possible settings	See SCTAB Parameter Syntax.
Default setting	As specified within the macro `NTSCTAB` in `NATCONFG`.
Dynamic specification	yes	This parameter can only be specified dynamically. In the Natural parameter module, the macro `NTSCTAB` is used instead.
Specification within session	no

Notes:

The NTSCTAB scanner character type table defines the properties of characters used in mask definitions for the MASK option and recognized as delimiters in the EXAMINE and SEPARATE statements.
If the CP profile parameter is set to a value other than OFF, values specified with SCTAB are ignored. See also Translation Tables in the Unicode and Code Page Support documentation.

The following topics are covered below:

SCTAB Parameter Syntax
NTSCTAB Macro Syntax
Example of SCTAB Parameter
Examples of NTSCTAB Macro

SCTAB Parameter Syntax

The SCTAB parameter is specified as follows:

SCTAB=(character1,attribute-type1,attribute-type2,...,character2,attribute-type1,attribute-type2,...)

Note:
It is possible to specify more than one character in the list of values. You must enclose the entire string of characters/attribute pairs in parentheses.

Or:

SCTAB=OFF

Where:

Syntax Element / Value	Explanation
`character`	You specify a character, and after it its attribute type(s). You can specify the character either as the one-byte character itself (enclosed in apostrophes) or as the hexadecimal representation of that character.
`attribute-type`	Attribute types can be:
	`UPPER`	upper-case alphabetical
	`LOWER`	lower-case alphabetical
	`NUM`	numeric
	`HEX`	hexadecimal
	`ALFANUM`	alphanumeric
	`SPECIAL`	special
	`NDELIM`	non-delimiter
`OFF`	With `SCTAB=OFF`, all (static and dynamic) definitions are reset to the values specified within the macro `NTSCTAB` in `NATCONFG`.

NTSCTAB Macro Syntax

The NTSCTAB macro is specified as follows:

         NTSCTAB=character,attribute-type,attribute-type...
         NTSCTAB=character,attribute-type,attribute-type...

Notes:

For an explanation of the syntax elements, see SCTAB Parameter Syntax.
The value OFF cannot be specified with the macro NTSCTAB, but only dynamically with the profile parameter SCTAB.
For each character to be overwritten, you have to specify a separate NTSCTAB macro; see Examples of NTSCTAB Macro..

Example of SCTAB Parameter

SCTAB=(5E,LOWER,NDELIM,'ß',SPECIAL,7B,SPECIAL,'Ä',UPPER,NDELIM)

Examples of NTSCTAB Macro

         NTSCTAB  5E,LOWER,NDELIM
         NTSCTAB  'ß',SPECIAL
         NTSCTAB  7B,SPECIAL
         NTSCTAB  'Ä',UPPER,NDELIM

SEARCH CONTENTS | PDF BOOKS | HOME UP PREV NEXT