This Natural profile parameter can be used to overwrite the definitions
in the translation table NTTABL as contained in the
configuration module
NATCONFG. TABL
corresponds to the NTTABL
macro in the Natural parameter module.
| Possible settings | See TABL Parameter Syntax. | |
|---|---|---|
| Default setting | As specified within the macro
NTTABL in
NATCONFG.
|
|
| Dynamic specification | yes | This parameter can only be specified dynamically. In the
Natural
parameter module, the macro NTTABL is used
instead.
|
| Specification within session | no | |
Note:
The NTTABL table in NATCONFG is
used to translate output produced by programs located in SYS...
libraries.
The following topics are covered below:
The TABL parameter is specified as follows:
| TABL=(a1,a2,b1,b2,c1,c2,...) |
You specify pairs of characters, the first character of a pair being the character to be translated, the second character of a pair being the character into which the first character is to be translated.
You can specify each character either as the one-byte character itself (enclosed in apostrophes) or as the two-byte hexadecimal representation of that character.
Or:
| TABL=OFF |
With TABL=OFF all (static and dynamic) definitions are
reset to the values specified within the macro NTTABL in
NATCONFG.
The NTTABL macro is specified as follows:
NTTABL a1,a2,b1,b2,c1,c2,...
Notes:
OFF cannot be specified with the macro
NTTABL, but only dynamically with the profile parameter
TABL.
With the TABL parameter, you must enclose the
entire string of character pairs in parentheses, for example:
TABL=(5E,'Ä','ö',78,FF,00,'ü','Ü')
NTTABL 5E,'Ä','ö',78,FF,00,'ü','Ü'
In this example, the character represented by H'5E' is
translated into 'Ä', 'ö' into the character
represented by H'78', the character represented by
H'FF' into the character represented by H'00', and
'ü' into 'Ü'.