This Natural profile parameter allows you to specify subparameters which
control the handling of Natural RPC. It corresponds to the macro
NTRPC
in the parameter module NATPARM.
| Possible settings | See RPC Parameter Syntax. | |
|---|---|---|
| Default setting | none | See Keyword Subparameters. |
| Dynamic specification | yes | This parameter can only be specified dynamically. In the Natural
parameter module NATPARM, the macro
NTRPC is
used instead.
|
| Specification within session | no | |
The following topics are covered below:
Note:
See also Setting Up a Natural RPC
Environment in the
Natural Remote
Procedure Call (RPC) documentation.
The parameter syntax of RPC is as follows:
| RPC=(keyword-subparameter=value,keyword-subparameter=value,...) |
For names and values of
keyword-subparameter, see
Keyword
Subparameters.
On the client side, the syntax of the NTRPC macro
in the Natural parameter module is as follows:
NTRPC ACIVERS=value, *
AUTORPC=value, *
COMPR=value, *
CPRPC=value, *
DFS=value, *
MAXBUFF=value, *
RDS=value, *
RPCSDIR=value, *
RPCSIZE=value, *
SERVER=value, *
TIMEOUT=value, *
TRYALT=value
On the server side, the syntax of the NTRPC macro
in the Natural parameter module is as follows:
NTRPC ACIVERS=value, *
CPRPC=value, *
LOGONRQ=value, *
MAXBUFF=value, *
NTASKS=value, *
RPCSIZE=value, *
RPCUCT=value, *
SERVER=value, *
SRVCMIT=value, *
SRVNAME=value, *
SRVNODE=value, *
SRVRTRY=value, *
SRVTERM=value, *
SRVUSER=value, *
SRVWAIT=value, *
TRACE=value, *
TRANSP=value
For detailed information on these keyword subparameters, follow the links in the section Keyword Subparameters.
There are three groups of keyword subparameters that apply to:
Both Client and Server ACIVERS
| CPRPC |
MAXBUFF |
RPCSIZE |
SERVER
Server Only
LOGONRQ |
NTASKS |
RPCUCT |
SRVCMIT |
SRVNAME |
SRVNODE |
SRVRTRY |
SRVTERM |
SRVUSER |
SRVWAIT |
TRACE |
TRANSP
Note:
See also
Set the RPC Server-Specific Natural
Parameters in the
Natural Remote
Procedure Call (RPC) documentation..
Client Only
AUTORPC |
COMPR |
DFS |
RDS |
RPCSDIR |
TIMEOUT |
TRYALT
Note:
See also
Set the RPC Client-Specific Natural
Parameters in the
Natural Remote
Procedure Call (RPC) documentation..
For the client:
RPC=(RPCSIZE=80,MAXBUFF=30,AUTORPC=ON,DFS=(MYSERV,MYNODE,,ACI))
For the server:
RPC=(RPCSIZE=80,MAXBUFF=30,SRVNAME=MYSERV,SRVNODE=MYNODE,SERVER=ON)
For the client:
NTRPC RPCSIZE=80, *
MAXBUFF=30, *
AUTORPC=ON, *
DFS=(MYSERV,MYNODE1,,ACI), *
RDS=((SRVX,NODEX),(SRVY,NODEY))
For the server:
NTRPC RPCSIZE=80, *
MAXBUFF=30, *
SRVNAME=MYSERV, *
SRVNODE=MYNODE, *
SERVER=ON