Record data transfer buffers to disk.
The data transfer buffers are written to the file Xfer.trc in the log/trace directory. If the file does not yet exist, it is created. If the file does exist, the new data transfer buffers are appended to it.
Data transfer buffers are recorded until you issue the
REC_XFER command again. Using a key combination, you
can switch this mode on and off.
The default key combination depends on the type of session and the corresponding default key scheme.
| Type of Session / Default Key Scheme | Default Key Combination |
|---|---|
| TN3270 / SAGKEYS1 | CTRL+F |
| BS2000 / BS2000KEYS | CTRL+X |
| VTxxx / VT220PC | ALT+F |
Important:
This command is provided for Entire Connection problem resolution
and should only be used with the assistance and direction of your technical
support.
During terminal emulation, the character X is shown in column 80 of the
status line when REC_XFER is active.
REC_XFER
None
| Procedure File: | Yes |
| Command Line: | No |
| Key: | Yes |
| API: | Yes |
