DUMP |
This command is used to provide information for Software AG technical support personnel in order to locate an error that caused an abnormal termination (abend) of the Natural system. Forward this information to Software AG technical support for error diagnosis and correction.
DUMP |
Displays abend information (core contents). | |
DUMP
SRCE |
Lists source changes applied to products linked to the current Natural nucleus. | |
DUMP
SSRC |
Lists special source changes applied to products linked to the current Natural nucleus. | |
DUMP
SVAR |
Displays TP monitor and operating system dependent system variables and additional information. | |
DUMP
ZAPS
or DUMP SZAP
|
Lists Zaps (DUMP ZAPS ) or special
Zaps only (DUMP SZAP ) applied to products linked to the current Natural
nucleus.
|
|
product-code |
Lists Zaps applied to a single product linked to the current
Natural nucleus.
All valid product codes are listed in Overview of New Natural Add-On Product Versions in the current Natural Release Notes for Mainframes. There are three special product codes: |
|
module-name |
Lists Zaps applied to a module that is not linked to the current
Natural nucleus but concatenated to the Natural load library in the Natural
execution JCL or in the appropriate library of the TP monitor program.
Software AG technical support personnel will advise you of the required module name. |
|
DUMP
ABEND or DUMP
ABND |
Displays an overview of all important information after a program check (NAT0054) occurred, like Program name, Line number, registers, PSW, etc. |
|
DUMP
CSECTS or DUMP
CSCT |
Shows all CSECTs in the nucleus. |
|
DUMP EPLS |
Shows all 3-GL routines that have been linked to the nucleus, as well as the number of calls. |
|
DUMP EPLN |
Like DUMP EPLS, but sorted by name. |
|
DUMP EPLP |
Like DUMP EPLS, but sorted by program. |
|
DUMP
? or DUMP
HELP |
The |