This Natural profile parameter can only be specified with the
NTIMSP
macro, dynamic parameter specification is not possible
yet.
The NTIMSP
macro is used to set general parameters for the
Natural IMS TM Interface.
The NTIMSP
macro can be specified only once in the
Natural
parameter module.
Possible settings | See below. |
---|---|
Default setting | See below. |
Dynamic specification | no |
Specification within session | no |
This section covers the following topics:
The NTIMSP
macro is specified as follows:
NTIMSP NIINAME=value, * SUBPOOL=value, * THRELO=value, * TRNCODE=value
NIINAME
|
SUBPOOL
|
THRELO
|
TRNCODE
NIINAME=value
specifies the
name of the Natural IMS TM Interface module to be used by the current driver.
Value | Explanation |
---|---|
1- 8 characters | A valid module name. |
NIIINTFM |
This is the default value. |
SUBPOOL=value
specifies the
z/OS subpool to be used for storage requests.
Value | Explanation |
---|---|
0 - 127 |
The number of a z/OS task-related subpool used by a problem state program. |
125 |
This is the default value. |
THRELO=value
determines whether
the Natural storage thread can be allocated at a different virtual address
after a terminal I/O.
Value | Explanation |
---|---|
ON |
Thread relocation is enabled: the Natural thread
can be allocated at a different virtual address after a terminal I/O.
This is the default value. |
OFF |
Thread relocation is disabled and the Natural
thread remains at the same virtual address.
The size of the Natural thread is determined by the first Natural session that allocates the thread. As a consequence:
Note: |
TRNCODE=value
can be used to
identify the transaction code.
Value | Explanation |
---|---|
ON |
The TRNCODE keyword subparameter is
activated to evaluate the TRNCODE parameter:
|
OFF |
The TRNCODE keyword subparameter is
deactivated.
This is the default value. |
NTIMSP NIINAME=NATIMS1,SUBPOOL=0