This Natural profile parameter specifies the number of attempts for an RPC server to connect/reconnect (REGISTER) to an EntireX Broker that is not active, and the wait time between two successive attempts.

Possible settings	See SRVRTRY Parameter Syntax.
Default setting	0,60	No attempts.
Dynamic specification	yes
Specification within session	no

Note:
SRVRTRY is specified on the server side only.

SRVRTRY Parameter Syntax

The SRVRTRY parameter syntax is as follows:

SRVRTRY=(attempts,wait-time)

Or:

SRVRTRY=attempts

Note:
If only a value for attempts is specified, the parentheses may be omitted.

Where:

Syntax Element	Value	Explanation
attempts	0 or 1 - 2147483647	Number of attempts to connect/reconnect to an EntireX Broker that is not active (EntireX Broker message 02150148). Notes: The specification of attempts enables you to start a Natural RPC server before the required EntireX Broker has been started and to shutdown an EntireX Broker temporarily without implicitly terminating all Natural RPC servers. If the EntireX Broker is still not active after the number of attempts specified in attempts or if attempts is zero, the RPC server terminates.
wait-time	0 or 1 - 3600	Wait time in seconds between two successive attempts.

Examples

1. RPC=(SRVRTRY=(20,10))

   Or:

            NTRPC SRVRTRY=(20,10)

   20 attempts with a wait time of 10 seconds between two successive attempts.

2. RPC=(SRVRTRY=500)

   Or:

            NTRPC SRVRTRY=500

   500 attempts with a wait time of 60 seconds between two successive attempts.

Note:
For further information, see the Natural Natural RPC (Remote Procedure Call) documentation, and especially Considerations for Mainframe Natural RPC Servers with Replicas.