You can store data and/or leave the editor by using any of the following main commands:
Main Command | Explanation |
---|---|
CANCEL |
Leaves the editor. Any changes made during this editing session do not take effect. |
END |
If AUTOSAVE is ON , stores
data including any changes, and leaves the editor. If
AUTOSAVE is OFF , the
END main command acts as a
CANCEL command if no data was modified. If changes
were made, a message asks you to issue a SAVE or
CANCEL command.
|
SAVE |
Stores the data (including any changes) currently contained in the source work area of the editor. The editing session continues. |