Version 6.3.8 for Windows
 —  Parameter Reference  —

RDS - Define Remote Directory Server

This Natural profile parameter allows you to define up to 10 remote directory servers. For each remote directory server, you specify up to 5 subparameters.

RDS is specified on the client side only.

Possible settings
server-name The server name (1 - 8 characters). There is no default, the value must be specified.
server-node The server node (1 - 8 characters). There is no default, the value must be specified.
subprogram The name of the subprogram titled CALLNAT, (1 - 8 characters) to be used as interface (default is RDSSCDIR).
logon-indicator

A logon indicator. If nothing is specified, blank is the default.

L The client initiates a Natural logon to the server with the library name of the current library on the client.
blank No server logon will be executed.
Note for Windows platforms: instead of L, check the selection box.
transport-protocol-name

The transport protocol to be used. ACI is the only possible value and the default.

Default setting none Subparameter defaults, see above.
Dynamic specification yes See below.
Specification within session no  

For dynamic specification the syntax is as follows.

Using 1 server:

RDS=(server-name,server-node-name,subprogram,logon-indicator,transport-protocol-name)

Using 2-10 servers:

RDS=((server-name,server-node name,subprogram,logon-indicator,transport-protocol-name)(server-name,server-node name,subprogram,logon-indicator,transport-protocol-name)...(server-name,server-node name,subprogram,logon-indicator,transport-protocol-name))

For additional information on Natural RPC, see the Natural Remote Procedure Call (RPC) documentation.

Top of page