Version 6.3.8 for Windows
 —  Natural for Ajax  —

Usage of Edit Masks

This document covers the following topics:


General Information

Natural for Ajax supports a subset of the Natural edit mask concept, in order to support output formatting and input validation of numeric fields.

If an edit mask is specified for a numeric field, the field content is rendered according to the edit mask. Input to this field is validated against a regular expression that corresponds to this edit mask. The regular expression is automatically generated from the edit mask, so that by defining the edit mask, the user controls at design time the formatting of the field as well as the validation.

During the output formatting and input validation for numeric fields with edit masks, the Natural parameters DC, THSEPCH and EMFM are supported.

Top of page

Data Types with Edit Masks

In all controls that support the property datatype, an edit mask can be specified for the following data types:

Top of page

Characters Used in Edit Masks

The following characters can be used in edit masks:

Character Function
9 Decimal digit or digit.
Z Zero-suppressed digit.
+ Preceding/following sign.
- Preceding/following sign if the value is negative.
, Thousands separator character.

Note:
The actual character used as the thousands separator can be either a comma (,) or a period (.). This depends on the setting of the parameter THSEPCH in Natural.

. Decimal separator character.

Note:
The actual character used as the decimal separator can be either a period (.) or a comma (,). This depends on the setting of the parameter DC in Natural.

Top of page

Specifying Edit Masks in Layouts

An edit mask is added to a numeric data type in the following way (the edit mask is separated from the data type by a semicolon):

Properties

Application Designer generates a regular expression from the edit mask and adds it as a value for the validation property. This regular expression is used to validate the value on the client side when the user changes the field. This is done in the same way as if the user had specified the regular expression directly in the validation property.

The generated regular expression can be seen in the generation protocol. For the above example, it is shown as follows:

Generation protocol

The validation takes place after the modification of a field value, that is: when the focus has left the field. This means that the validation does not take place with every key pressed. The user can enter invalid values as long as the input focus is in the field.

Input Rendering

For ZZ,ZZ9.99 of the above example, the user can enter a valid value even without entering the thousands separator character:

Example

Since the value itself is correct, it is accepted. Ideally, the value should be rendered according to the precise edit mask when the focus of the field is left. This can be easily achieved by setting the flush property to "server". This will trigger a server roundtrip and since output rendering takes place with each server roundtrip, the rendering is done automatically.

Example

Input Completion

Application Designer does some input completion, for example, when working with float data types. An example for this is adding "0" decimal digits.

Example

For the above input, Application Designer will do the following input completion:

Example

Top of page

Static versus Dynamic Validation

At design time, the characters that will actually be used for DC and THSEPCH are not yet known. Therefore, when the regular expression for validation is already generated at design time, both characters must be considered as possible DC or THSEPCH characters. In consequence, the validation is more tolerant than it should be.

To achieve a more stringent validation, the regular expression can also be dynamically generated at runtime. This is achieved by appending the literal "dynamic" to the edit mask, separated by a semicolon. In this case, the runtime settings of DC and THSEPCH are evaluated during the validation. Example:

datatype="N 5.4;+ZZ,999.99;dynamic"

If the parameter EMFM is to be evaluated, the validation expressions must be generated dynamically, because at design time, it is not yet known whether the application will run in free mode or not. Statically generated validations always behave as in free mode. That is: they do not force the user to enter plus or minus signs or the thousands separator character.

Top of page