You can generate single or multiple stub subprograms (interface objects)
in either online or batch mode by using the command SYSRPC
SGMASS.
You generate stub subprograms from subprograms.
This section contains information on:
You can enter the command SYSRPC
SGMASS at any NEXT or MORE command prompt for generating stub
subprograms online.
The section below contains information on:
The syntax that applies to SYSRPC SGMASS is
illustrated in the diagram below:
SYSRPC SGMASS
[name]
[compression]
|
The syntactical items name and compression are explained in the section Name Specification and Compression.
The command SYSRPC SGMASS produces a report
that lists the stub subprograms (objects) generated with the command as shown
in the following example:
Page 1 2006-05-24 16:09:17
SYSRPC - Stub Generation in Library SAGTEST
Generation Criteria:
Object name or range: RPC*
Compression: 1
Generation Results:
Number of objects found: 8
Maximum send length: 200228
Maximum receive length: 1024192
Object Type Send Length Receive Length Message
-------- ---- -------------- -------------- --------------
RPCCALL1 N 209 202
RPCCALL2 N 219 240 Compression=2
RPCCALL3 N 204 193
MORE
|
The report is organized in three sections, which contain the following information:
Generation Criteria:
The criteria based on which the stub subprogram(s) were generated: a
single object name or a range of names (here: RPC*) and the
compression (here: 1).
Generation Results:
The number of objects selected for the stub generation.
The maximum buffer sizes all generated stub subprograms require for sending and receiving data from the client.
Object List:
The name and type (here: N for type subprogram) of each
generated stub subprogram. The buffer sizes each object requires for sending
(Send Length) and receiving (Receive
Length) data from the client. A possible comment on each stub
generation in the Message column. In the example above,
Compression=2 indicates that object RPCCALL2 was not
generated with Compression 1 as requested in the command. The object list is
sorted in alphabetical order of object names.
If the MORE prompt appears, choose ENTER to scroll to the end of the report.
If the stub generation fails for single or multiple objects, the report shows the number of objects affected and appropriate error messages.
You can specify the objects (subprograms) to be selected for stub generation and the type of compression to be used:
You can specify an object name or a range of names. The specification of an object name or a range of names is optional.
 |
Warning: If you do not specify an object name or a range of names, with few exceptions (see below), all subprograms in the current library will be converted to stub subprograms. |
Valid name specifications are described below where value is any combination of one or more alphanumeric characters:
| Input | Objects Selected |
|---|---|
| * |
All subprograms. This is the default setting. |
| value | A subprogram with a name equal to value. |
| value* |
All subprograms with names that start with value. |
| value | All subprograms with names less than or equal to value. |
| value | All subprograms with names greater than or equal to value. |
In the Natural system library SYSRPC, SYSRPC
SGMASS exempts from stub generation all subprograms with names
that start with any of the following prefixes: RDS, RPC, NAT, NAD or NSC.
In user libraries, SYSRPC SGMASS exempts
from stub generation the subprogram NATCLTGS.
You can specify any of the following compression types: 0,
1, 2. The specification of compression is optional.
The default type used for stub generation is 1.
See also Using Compression described in Operating a Natural RPC Environment in the Natural Remote Procedure Call (RPC) documentation.
