This section describes the condition codes returned for Object Handler functions in batch mode and the user exit routines available for function processing.
Object Handler processing in batch mode terminates with one of the following condition codes:
| Condition Code | Explanation |
|---|---|
| 0 | Object Handler process terminated successfully. |
| 30 | An internal Object Handler error occurred. |
| 40 | An error was detected in the Object Handler command. |
| 50 | An error occurred during Object Handler processing. |
| 60 | A Natural Security error occurred during Object Handler processing. |
| 99 | A Natural error occurred during Object Handler processing. |
The Object Handler user exit routines are supplied as source objects in the Natural system library SYSOBJH. These source objects are named SRC-EXnn, where nn denotes the number of the user exit routine.
To activate a user exit routine
CATALOG or STOW
source object SRC-EXnn under the name
OBJHEXnn in the Natural system library
SYSOBJH.
Different names are used to guarantee that the source object (possibly modified according to your requirements) and the cataloged object of the user exit routine are not overwritten by an update installation.
For detailed descriptions of the user exit routines, see the source objects of SRC-EXnn in the library SYSOBJH.
The following user exit routines are available:
Whenever a condition code is set to a value greater than 0 (zero) in batch mode, the user exit routine OBJHEX01 (if available) will be invoked before the Object Handler stops processing. With this user exit routine, you can specify whether to continue or terminate Object Handler processing. In the case of termination, you can change the condition code. For further details, see the source of the user exit routine SRC-EX01 in the Natural system library SYSOBJH.
If the Object Handler load function was executed successfully in batch mode (with Condition Code 0), but one or more objects were rejected during loading (for example, not replaced), before the Object Handler stops processing, the user exit routine OBJHEX02 (if available) is invoked. With OBJHEX02, you can specify whether to continue or terminate Object Handler processing. In the case of termination, you can set a condition code. For further details, see the source of the user exit routine SRC-EX02 in the Natural system library SYSOBJH.
