Version 4.2.6 for Mainframes
 —  Parameter Reference  —

NC - Use of Natural System Commands

This Natural profile and session parameter controls whether Natural system commands can be used during the Natural session or not.

Within a Natural session, the profile parameter NC can be overridden by the session parameter NC.

Possible settings ON

System commands cannot be used - except FIN, LAST, LOGOFF, LOGON, MAINMENU, RENUMBER, RETURN, SETUP and TECH.

If you have Natural Security installed, any system command restrictions you set with Natural Security are valid, regardless of the setting of the NC profile parameter.

In a Natural Development Server environment on mainframe computers, the value OFF will be assumed for the Natural Development Server, even if NC=ON has been specified.

If NC=ON has been specified on the client side, subsequent system commands issued on the client side will be rejected as described above.

OFF All system commands can be used.
Default setting OFF
Dynamic specification yes
Specification within session yes Applicable Statements: SET GLOBALS
Applicable Command:  
Application Programming Interface USR1005N See SYSEXT - Natural Application Programming Interfaces in the Utilities documentation.

Note:
Natural terminal commands and user-created commands (object module names) are not affected by the NC parameter.

Top of page