
	Version 4.2.6 for Mainframes	SEARCH INDEX CONTENTS \| PDF PAGE PDF BOOKS \| HOME UP PREV NEXT

— Parameter Reference —

LC - Lower to Upper Case Translation

This Natural profile parameter controls lower-case to upper-case translation of input characters.

Note:
This parameter does not apply to Natural stack data which was placed on the Natural stack by the STACK statement.

Possible settings	`ON`	No translation of lower-case characters to upper case is performed.
Possible settings	`OFF`	All lower-case characters, except input from the Natural stack which was place there by the `STACK` statement, is translated to upper case by Natural.
Default setting	`OFF`
Dynamic specification	yes
Specification within session	yes	To disable or enable lower-case to upper-case translation dynamically within the active Natural session, you should use the terminal commands `%L` or `%U`
Application Programming Interface	`USR1005N`	See SYSEXT - Natural Application Programming Interfaces in the Utilities documentation.

Notes:

Lower/upper-case translation can also be performed by a TP monitor before control is given to Natural. The corresponding TP-monitor parameters for lower/upper-case translation also have to be reviewed to ensure correct translation.
A user-supplied translation table can be used to perform translation from lower case to upper case; see NTUTAB1 macro (contained in the UTAB1 profile parameter description).

SEARCH INDEX CONTENTS | PDF PAGE PDF BOOKS | HOME UP PREV NEXT