This Natural profile parameter allows you to overwrite the definitions in
the translation table NTUTAB1 as contained in the configuration
module NATCONFG.
The NTUTAB1 table is used for lower-to-upper-case translation.
UTAB1 corresponds to the
NTUTAB1
macro in the Natural parameter module NATPARM.
| Possible settings | See UTAB1 Parameter Syntax below. | |
|---|---|---|
| Default setting | As specified within the macro NTUTAB1 in
NATCONFG.
|
|
| Dynamic specification | yes | This parameter can only be specified dynamically. In the Natural
parameter module NATPARM, the macro
NTUTAB1 must be used instead.
|
| Specification within session | no |
The following topics are covered below:
The UTAB1 parameter is specified as follows:
| UTAB1=(a1,a2,b1,b2,c1,c2,...) |
You specify pairs of characters, the first character of a pair being a lower-case character to be translated, the second character of a pair being the upper-case character into which the lower-case character is to be translated.
You can specify each character either as the one-byte character itself (enclosed in apostrophes) or as the two-byte hexadecimal representation of that character.
The NTUTAB1 macro is specified as follows:
| NTUTAB1 a1,a2,b1,b2,c1,c2,... |
NTUTAB1 5E,'Ä','ö',78,FF,00,'ü','Ü'
In this example, the character represented by H'5E' is
translated into 'Ä', 'ö' into the character
represented by H'78', the character represented by
H'FF' into the character represented by H'00', and
'ü' into 'Ü'.
With the UTAB1 parameter, you must enclose the entire
string of character pairs in parentheses, for example:
UTAB1=(5E,'Ä','ö',78,FF,00,'ü','Ü')
