Version 4.2.6
 —  Parameter-Referenz  —

TABL - SYS Library Output Translation

This Natural profile parameter allows you to overwrite the definitions in the translation table NTTABL as contained in the configuration module NATCONFG. The NTTABL table is used to translate output produced by programs located in SYS... libraries.

TABL corresponds to the NTTABL macro in the Natural parameter module NATPARM.

Possible settings   See TABL Parameter Syntax below.
Default setting   As specified within the macro NTTABL in NATCONFG.
Dynamic specification yes This parameter can only be specified dynamically. In the Natural parameter module NATPARM, the macro NTTABL must be used instead.
Specification within session no  

The following topics are covered below:


TABL Parameter Syntax

The TABL parameter is specified as follows:

TABL=(a1,a2,b1,b2,c1,c2,...)

You specify pairs of characters, the first character of a pair being the character to be translated, the second character of a pair being the character into which the first character is to be translated.

You can specify each character either as the one-byte character itself (enclosed in apostrophes) or as the two-byte hexadecimal representation of that character.

Seitenanfang

NTTABL Macro Syntax

The NTTABL macro is specified as follows:

NTTABL a1,a2,b1,b2,c1,c2,...

Seitenanfang

Example of NTTABL Macro

NTTABL 5E,'Ä','ö',78,FF,00,'ü','Ü'

In this example, the character represented by H'5E' is translated into 'Ä', 'ö' into the character represented by H'78', the character represented by H'FF' into the character represented by H'00', and 'ü' into 'Ü'.

Seitenanfang

Example of TABL Parameter

With the TABL parameter, you must enclose the entire string of character pairs in parentheses, for example:

TABL=(5E,'Ä','ö',78,FF,00,'ü','Ü')

Seitenanfang